ProMeth PM75 Water Methanol Injection Pump (20 GPH/1260CC PER MINUTE @ 190 PSI)

Industry Standard Pump
This is the industry standard water methanol injection pump and what most water methanol injection companies are using. Its commonly identified as a 1.0 gallon per minute open flow pump with a 10-11 AMP sticker rating depending on the pumps factory preset pressure bypass setting of either 200-220 psi. Its not well suited for direct port applications due to its limited flow/pressure potential. However still a great choice for many single or dual nozzle applications under the 600 horsepower mark.
Features Include:
Pressure adjustable from 100-300 PSI
3/8 NPT female inlet & outlet port
Motor turns 1500 RPM @ 12 volts  
11 amp draw
Built-in bypass valve
Built-in thermal protection
Built-in anti reverse check valve 
Built-in heat sink on back of motor
Heavy duty dual EPDM pump seals   
Pressure adjustable from 100-300 PSI
Can run dry up to 1 hour without damage
100% methanol compatible
Tested prior to shipping 
Made in the USA
Weight 5.2 lbs
Flow & Horsepower Ratings @ 13.5 Volts:
1.1 gallons per minute openflow
Use 12 gauge wire for power and ground
75 liters per hour @ 190 PSI
20 gallons per hour @ 190 PSI
1260 cubic centimeters @ 190 PSI
Supports up to 1200-1400 horsepower - 100% water mix 
Supports up to 700-900 horsepower - 50/50 water methanol mix
Supports up to 500-600 horsepower - 100% methanol mix
Special Notes:
Do not use with petroleum products (E85, E98, gasoline, diesel, etc) 
Does not include pump fittings. Pump fittings are available for sale separately
Pumps come preset at 200 PSI - Expect 4-5 years of service if pump pressure is left at 200 PSI or below
Running the pump over 250 PSI is not advised and will shorten pumps life
All tests were performed using a 6AN stainless steel braided hose on the inlet side of pump
Using 1/4" outside diameter nylon on the inlet side of the pump will reduce pump performance and flow output
Pump may be mounted vertical or horizontal